JBL 5 Channel 800W RMS Class AB + D High Performance Car Amplifier CLUB A5055
JBL Club Series 5 Channel Car Amplifer -50w RMS x 4 at 4 ohms 800w RMS A5055
This Listing Includes:
(1) Club A5055 Five Channel Amplifier
(1) Remote bass Control Module
(1) 16.5' Remote Control Cable
(1) Owner's Manual
(2) Self-Tapping Screws for remote (M3 x 15mm)
(4) Mounting Screws(M4 x 53mm)
(4) Wire To RCA Adapters
(6) 30A ATO Fuses (3 installed, 3 Spare)
The Club A5055 5-channel amplifier delivers a powerful 50-Watts RMS to each of the front and rear speakers in your car, and a pounding 500-Watts RMS to the subwoofer channel — a much smarter ratio of subwoofer-to-full-range power than what is typical in 5-channel amps. You can also bridge the amp to 3-channel mode to deliver 140-Watts RMS to your front speakers while driving your sub with 500-Watts RMS. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car's factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics. The subwoofer channel features a low-pass crossover, selectable bass boost, and phase switch to optimize subwoofer performance.
The JBL Club A5055 Amplifer Features a low-profile Chassis and and a small overall fottprint to fit in more vehicles where available space is limited.
Speaker-level and low-level imputs allow the Club A5055 to integrate with both aftermarket and factory car stereo systems.
Unlike many amplifiers available at similar prices, the JBL Club A5055 Features variable electronic crossoversa nd bass boost circuits allowing fro precise system tuning and performance.
The Club A5055 has been engineered using Balanced Differential Inputs to ensure low noise and distortion even at high output levels. This also Makes it far less susceptible to line induced radiated engine noise.
When the low-level inputs are used, this control adjusts the input sensitivity between 200mVrms and 2.0Vrms. When high - level inputs are used, this control adjusts the input sensitivity between 2Vrms and 20Vrms.
On-Board Circutry protects the Club A5055 from shorts, high-teperature, overvoltage and undervoltage. An LED indicator is provided to let you know when one of these conditions exists.
On-board circuitry protects the Club A5055 from shorts, high-temperature, overvoltage and undervoltage. An LED Indicator is provided to let you know when you know when one of these conditions exists.
Phase Switch Changes the input phase to inverted or non-inverted. This is especially helpful with the subwoofer channel.
The RBC Wired Remote is an Easy installation and can be mounted for convenient volume adjustment from driver's seat.
50 watts RMS x 4 + 320 watts RMS x 1 at 4 ohms
65 watts RMS x 4 + 500 watts RMS x 1 at 2 ohms
140 watts RMS x 2 bridged at 4 ohms + 500 watts RMS x 1 at 2 ohms
variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
low-pass filter (32-320 Hz, 12 dB/octave) on subwoofer channel
bass boost on subwoofer channel (0-12dB at 45Hz)
phase switch on subwoofer channel (0, 180 degrees)
fuse rating: 30Ax3
4-Gauge power and ground leads
WxHxD=360mm x 51.3mm x 180mm